Troubleshooting - Black & Decker KitchenTools MILL & BREW CM5000BCKT Guide D'utilisation Et D'entretien

TR OU B L E SHOOTI N G
PROBLEM
Coffee maker does
not turn on.
Coffee maker
is leaking.
The brew basket
overflows.
Coffee sediment in
brewed cup of coffee.
The coffee maker
brews slowly.
Grinder does not
turn on
If additional assistance is needed, please contact our consumer service team at
POSSIBLE CAUSE
Coffee maker is not
plugged in.
Water reservoir may be
overfilled.
Carafe may not be
correctly placed on the
"Keep Hot" carafe plate
The carafe has been
removed for longer than
20 seconds when using
the Sneak-A-Cup™ feature.
Excessive amount of
coffee is used.
The coffee has been
ground too finely.
The brew basket Sneak-
A-Cup™ mushroom may
be clogged with coffee
grounds.
Coffee grounds are small
enough to pass through
the permanent filter.
The coffee maker needs
cleaning.
Grinder overheated
1-800-231-9786.
15
SOLUTION
Make sure appliance
is plugged into a
working outlet.
Make sure water
reservoir has not
been filled beyond
the 12-cup MAX line.
Make sure carafe is
placed correctly on the
"Keep Hot" carafe plate.
Make sure to replace
the carafe within 20
seconds during the
brewing cycle.
Reduce the amount
of coffee used to
eliminate brew basket
overflows.
Adjust the grind
setting, cup selection,
to a lower cup
setting.
Free the brew basket
of coffee grounds by
pushing the mushroom
shaped Sneak-A-Cup™
part up and down
during rinsing.
While it is normal
to see some coffee
sediment when using
a permanent filter,
a coarser grind can
reduce the amount of
sediment.
Follow the instructions
in the "Descaling with
Vinegar" section
on page 14.
Let cool 15 minutes
and unplug unit for at
least 30 seconds to
reset fuse.