Eastman Outdoors 38263 Mode D'emploi page 9

Assemble Grinder Housing to Main Housing
Insert the Grinder Housing into the front opening of the main housing
by aligning the tabs on the black portion of the Main Housing with
those on the inside of the Grinder Housing according the markings
on the Main Housing. The chute should be angled toward the front
of the machine. Turn the Grinder Housing in a clockwise direction
to LOCK into place. The chute should then be in a vertical position
(Figure 1).
Assemble Feed Screw into the Grinder Housing
Insert Feed Screw into the front opening of the Head (Figure 2a and
2b). Insure that the end of the Feed Screw lines up correctly with the
drive shaft inside the Grinder Housing. Once properly lined up the
Feed Screw can be fully pushed into the Grinder Housing (Figure 3).
Figure 2b
Figure 1
Figure 2a
8
Insert this end of the Feed Screw into
the Grinder Housing
Figure 3