Eastman Outdoors 38263 Mode D'emploi page 10

Assemble Cutting Blade to Feed Screw
First orient the Cutting Blade so that the cutting edge (flat side of the
Cutting Blade) is facing away from the Feed Screw and then slide the
Cutting Blade onto the Feed Screw. Insure that the square opening
of the Cutting Blade fits over the square shaft of the Feed Screw.
Once properly lined up, the Cutting Blade can be fully pushed onto
the Feed Screw (Figure 4a and 4b).
Figure 4a
Assemble Cutting Plate to Grinder Housing
Push the Cutting Plate onto the front opening of the Grinder Housing.
Rotate the plate until the outer tabs line up with the slots in the
Grinder Housing. Once the Cutting Plate is properly lined up, the
Cutting Plate can then be fully pushed onto the Grinder Housing
(Figure 5a and 5b).
Figure 5a
Note: Insure that the tabs on the Cutting Plate are properly lined up
with the slots in the Grinder Housing (Figure 5b).
Figure 4b
Figure 5b
9