Publicité
Les langues disponibles
Les langues disponibles
Stuffing Casings for Brats, Sausages and Hot Dogs
Eastman Outdoors Sausage Kits (sold separately) are conveniently
packaged with casings or Eastman Outdoors Sausage Casings are
sold separately. Lay out the casing in front of the Grinder Housing
and place one end of the casing over the stuffing nozzle. Place your
already ground and marinated meat into the Hopper Tray. Plug in the
Grinder and then press the ON / OFF Switch to turn on the Grinder.
Use the Food Pusher to gently press the ground meat into the Grinder
Housing. Do not press so hard as to stall the grinder. Allow the meat
to be dispensed into the casing and as the casing fills with meat to your
desired sausage, brat or hot dog length then press the ON / OFF Switch
to turn off your Grinder. Then twist the casing several times to lock the
meat in the casing to your desired length. Turn the Grinder back on to
fill another length of casing and repeat the twisting procedure to lock the
meat in the casing to your desired length until the full length of casing is
filled with meat.
Filling Food Storage Bags
Place the Large Food Storage Stuffing Nozzle on the machine over your
chosen cutting blade and attach with the Locking Nut. The nozzle will
quickly your Food Storage Bags for later use.
Clearing Jams
There is a safety feature built into your Eastman Outdoors Professional
Electric Meat Grinder that will automatically disconnect power if a jam
occurs. Should this happen, immediately unplug the machine. Allow a
minute or two for the machine to cool down and reset. Plug in the unit
and press and hold the REV button to clear the jam. Release the REV
button. When the motor stops, unplug the unit. Remove the Locking
Nut, the Cutting Plate and the Cutting Blade and remove the debris that
has caused the jam. Once the jam is cleared reassemble the unit, plug
it in and begin normal operation again. The unit is built with an automatic
shut-off in case of an overload. If the unit shuts off automatically turn the
unit off, unplug it, and clear the food from the grinder. Wait a few minutes
for the unit to reset and then reassemble and use per instructions.
Disassembly
Be sure that the unit is turned off and unplugged before disassembling.
Remove the Locking Nut, Cutting Plate and Feed Screw. To remove
the Grinder Housing, press the black button on the Main Housing next
to the Grinder Housing and turn the Grinder Housing clockwise to the
"UNLOCK" position. Remove the Grinder Housing.
Cleaning
After use, turn the Grinder off and unplug from the wall outlet. Remove
the Locking Nut, Cutting Plate, Cutting Blade, Feed Screw and Grinder
Housing. Wipe the Main Housing with a damp cloth and dry thoroughly.
Wash the remaining items in hot, soapy water and dry thoroughly. The
Cutting Plates and Blade are stainless steel and may be washed in the
dishwasher. The plastic Nozzles can also be washed on the top rack
or using a no heat setting. No other parts should be washed in the
dishwasher. For storage you can apply a light coat of vegetable oil to
any or all of the metal parts.
13
Publicité
