Publicité
Les langues disponibles
Les langues disponibles
Certifications
CE-Konformitätserklärung
Wir, ZF Electronics GmbH, erklären, dass das Produkt
RS6600-C3R mit folgender Anforderung überein-
stimmt:
•
EMC-Richtlinie (Richtlinie zur elektromagnetischen
Verträglichkeit) 2004/108/EC, geprüft nach
EN 55022 und EN 55024
Getestet gemäß ZF Electronics-Standard-Testverfahren.
Declaration of CE Conformity
We, ZF Electronics GmbH, hereby declare that the
product RS6600-C3R fulfills the following requirement:
•
EMC Directive 2004/108/EC (directive on
electromagnetic compatibility), tested in
accordance with EN 55022 and EN 55024
Tested in accordance with ZF Electronics standard
test procedure.
Déclaration de conformité CE
Nous, ZF Electronics GmbH, déclarons que le produit
RS6600-C3R est conforme à l'exigence suivante:
•
Directive CEM (directive sur la compatibilité
électromagnétique) 2004/108/EC, contrôle suivant
EN 55022 et EN 55024
Testé suivant la procédure d'essai standard de
ZF Electronics.
Hinweis zum GS-Zeichen
Aufgrund der Position der Nulltaste des
Nummernfelds ist die Tastatur für Saldiertätigkeiten,
die überwiegend blind erfolgen, in Deutschland nicht
anzuwenden. Eine Tastatur mit nicht-deutscher
Tastenknopfbelegung ist in Deutschland aufgrund der
Zeichenbelegung (DIN 2137 Teil 2) nicht für den
Dauereinsatz an Bildschirmarbeitsplätzen zu
verwenden.
Federal Communications Commission
(FCC) Radio Frequency Interference
Statement
Information to the user: This equipment has been
tested and found to comply with the limits for Class B
digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the
following measures:
•
Reorientate or relocate the receiving antenna.
•
Increase the separation between the equipment
and receiver.
•
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/
TV technician for help.
Caution: Any changes or modifications not expressly
approved by the party responsible for compliance
could void the user's authority to operate the
equipment.
For UL
For use with Listed Personal Computers only!
7
Publicité
