Pre Operational Checks; Transport - Husqvarna Soff-Cut 150 Manuel D'utilisation

ASSEMBLING AND ADJUSTMENTS
• Turn the plunge adjustment screw clockwise by hand until
it touches the guide wheel shaft.
• Back off a quarter turn (counter-clockwise) and lock in
place by tightening the Plunge adjustment jam nut.
• Chase an existing saw joint for approximately one foot to
verify that the proper decorative cut is achieved.

Pre operational checks

The engine is delivered without oil. Fill with engine oil to the
correct level. Refer to Technical Data for recommendations on
which oil type to use.

Transport

• Remove the locking pin.
• Fold the handle forward.
• Fold the guide arm back.
• The saw should be lifted from the center handle on the roll
cage.
– 13
English