Benassi BL355 Manuel D'utilisation page 26

4.2.2 Start / Command
Operation of the engine
•
Put the oil in the crankcase of engine to arrive at suitable medium level
in the plug of level of the level. The lube is of the type used for the thermal
engines (15w-40).
•
Put gasoline in the fuel tank. It is right to use a automotive unleaded
gasoline.
Attention: For security motives, the clutch lever must be in release position.
(pic.2)
•
Put the accelerator level in little of speed position.(pic.3)
•
Pull the choke lever.(pic.4)
Attention: Don't use the choke when the engine is hot or the ambient
temperature is high.
•
Open a strainer of the fuel tank.(pic.5)
•
Put the engine switch in "ON" position. (pic.6)
•
Pull the recoil starter slowly until still a little pressure in the rope.
•
Pull firmly the starter knob. Have attention to the counterblow that is
exercised by the recoil starter of the engine.(pic.7)
•
When the engine started, put back progressively the choke lever. Don't
make it quickly because the engine tends to stop.
•
Put the lever of the accelerator on the wanted speed.
•
Press the clutch lever to the rotors start turning.
26
BL355 BL360
Picture 2
Picture 3
Picture 4
Picture 5
Picture 6
Picture 7