Benassi BL355 Manuel D'utilisation page 24

10.3 Transport
The tiller is conditioned in packing in cardboard, which protects all components. Once the open
packing, it is necessary to conduct the installation of the handlebar and the rotors, as the illustrations show
it (Point 4.1 of this manual).
After this installation, the manipulation of the machine is easier because it rests on front wheel, not
have to be pressure the clutch lever in the handlebar.
d id
el
10.4 Storage
In order to maintain the engine in good conditions, it is counselled to conform to the following points:
Drain the fuel tank.
Drain the gasoline of the carburettor through the drainage screw.
Change the oil of the crankcase.
Pull the starter handler until feeling resistance of the maximum compression (compression position)
Cover the engine and store it in a dry and clean place.
24
At the time of the opening of the cardboard and to take the machine of its packing, it is
right to be especially attentive and to pay a lot of attention in order not to get injured.
A particular attention must be brought when one approach of the rotors, that are cutting
objects and bass tones injuries can invoke to this title. Attention also to the supports of
wheel and to the handlebar in which one can stick itself the fingers.
BL355 BL360