Starting Up The Product Using A Magnet - Adeunis RF sigfox ANALOG PWR Guide Utilisateur

sigfox ANALOG PWR - Guide utilisateur / User guide version V1.2.0

5.8. Starting up the product using a magnet

Once the product has been configured and its assembly has been finalised, the product is ready to be started up.
The start-up is carried out using a magnet which you place on the upper part of the product (cf. the diagram below). The magnet must be held
in position for at least 6 seconds so as to confirm the start-up of the product.
Once the sigfox ANALOG PWR unit validates its start-up, it immediately transmits status frames followed by a data frame (according the defined
periodicity).
NB : Once the sigfox ANALOG PWR unit has started up, it cannot be switched off.
Position de l'aimant pour
démarrage du produit
EN
Page 71 of 73