MAINTENANCE
ANTI-HAIR WRAP TECHNOLOGY
The Anti-Hair wrap Technology
cleans. If some debris remains wrapped around the brush-roll, continue to run the
robot to give the brush-roll time to clean itself. If some hair wrap or debris remains
after continued cleaning, carefully remove it from the brush-roll.
To access the brush-roll, push up on the tabs on the
brush-roll door, then lift off the door.
NOTE: Replace brush-roll every 6 to 12 months, or when visibly worn. See sharkclean.eu for replacement parts.
MAINTAINING THE RESERVOIR AND MOPPING PAD
To clean pads, machine wash warm with light
colors. Use mild detergents and do not use bleach
or fabric softeners. Air-dry, or tumble-dry on low
with no dryer sheets.
NOTE: Before storing, make sure the reservoir and pad are completely dry. Store the reservoir and pad in a dry place to
prevent damage.
s h a r kc l e a n . e u
®
actively removes hair wrap while your robot
®
Lift out the brush-roll and remove any debris.
Reinstall the brush-roll, inserting the flat end first.
Close the brush-roll door and press down until both
sides click into place.
Empty the reservoir after each use. Rinse the
reservoir and let it air-dry. DO NOT put the reservoir
in the dishwasher.
MAINTENANCE
CLEANING SENSORS AND CHARGING CONTACTS
CLEAN SENSORS AND CHARGING CONTACTS AS NEEDED. With a dry cloth, gently dust off the sensors
and contacts located on the bottom of the robot and on the dock.
IMPORTANT: The robot uses cliff sensors to avoid stairs and other steep drops. Sensors may work less effectively when
they are dirty. For best results, clean sensors regularly.
CLEANING SIDE BRUSHES
CLEAN SIDE BRUSHES AS NEEDED.
NOTE: Remove and replace any side brushes that are bent or damaged. To remove a brush, lift it off its peg.
Carefully unwind and remove any string or hair
wrapped around brushes.
Gently wipe brushes with a dry cloth. To reinstall,
snap the brushes over the pegs. Spin the brushes
manually to make sure they are installed correctly.
s h a r kc l e a n . e u