IMPORTANT: The Shark® AI Robot VACMOP has a pre-installed rechargeable battery. Charge the battery
completely before first use. It may take up to 6 hours to fully charge.
To charge, place the robot on the dock. The Power
button on the side of the robot must be in the ON
position (I). The robot will beep when charging begins
and the charging indicator on the dock will turn from
green to blue.
If the robot has no charge or it cannot return to the
dock, manually place it on the dock. The indicator
light will turn blue and the robot will beep when it
is correctly placed on the dock.
NOTE: When manually placing the robot on the dock, make sure the Charging Contacts on the bottom of the robot are
touching the ones on the dock. While the robot is charging, both white LED lights will flash. When charging is complete,
both white lights will illuminate steadily.
NOTE: When picking up the robot, be careful not to place fingers between the bumper and the base of the robot.
s h a r kc l e a n . e u
CHARGING
When the cleaning cycle is complete, or if the battery
is running low, the robot will search for the dock.
If the robot doesn't return to dock, its charge may
have run out, or if it is in wet cleaning mode, the
dock may be blocked by carpet.
CHARGE INDICATOR LIGHTS
NOTE: If the low charge light is blinking red, there is not enough battery power for the robot to return to the dock.
Manually place the robot on the dock.
TIP: To preserve battery life, turn off the power switch if the robot will not be used for a long period of time. The robot
should be recharged at least once every three months. The switch must be in the ON position to charge the robot.
IMPORTANT: Before cleaning an entire room for the first time, we recommend that you first test your robot on a small
section of the floor to ensure there is no scratching.
In Use
Full
Partial
Low
Charge
Charge
Charge
(White)
(White)
(Red)
While
Charging
(White)
No Charge
or Off
The white charge indicator lights show how much
battery power is remaining.
While the robot is charging, both white LED lights
will flash. When charging is complete, both white
lights will illuminate steadily. It may take up to 6
hours to fully charge your robot.
If the robot is idle and away from the charging
dock for 10 minutes, it will enter Sleep Mode. The
indicator lights will turn off, but the battery and
Wi-Fi lights will remain on in sleep mode. Wake up
the robot by pressing any button.
s h a r kc l e a n . e u