shark AI ROBOT VACMOP Guide D'instructions page 21

USING THE SHARK® AI ROBOT VACMOP
WET MOPPING SETUP
When the reservoir has fluid and is properly installed,
with the mop pad attached, the robot is ready to
vacuum and mop simultaneously. Press the Clean
button on the robot or in the app to start a vacuuming
and mopping run. The robot will prime the mop pad
for 30 seconds before starting its run.
To remove the mop pad from the reservoir, detach
the pad from the back of the reservoir and slide the
pad out of the slot.
NOTE: When mopping, your robot may travel over
floor mats or rugs. Before the next mopping run, move
rugs or mats out of the robot's path, or use the app to
enable Carpet Detection or to set up no-go zones.
s h a r kc l e a n . e u
When mopping is complete, remove the reservoir by
pressing both buttons and sliding it out. Empty the
reservoir after each use.
CAUTION: Floors may be slippery after mopping.
Before your robot's first mopping run, set up Carpet
Detection in the app. This ensures your robot will
avoid carpets and rugs when mopping. Then follow
the instructions in the app to help the robot complete
its Explore Run, and then an initial vacuuming run.
Once the robot completes these runs, it will create
a map in the app, and you can select other areas for
the robot to avoid when mopping.
USING THE SHARK® AI ROBOT VACMOP
Please visit sharkclean.eu for answers to all your app questions.
USING THE SHARKCLEAN APP
Get the most out of your Shark AI Robot VACMOP with these app features:
• Recharge and Resume
Enable this feature to handle
multi-room cleaning in larger
homes. The robot will return
to the dock, recharge, and
Dining Room
Kitchen
Living Room om
can pick up where it left off.
• Carpet Detection
Once the robot has mapped
your home, activate Carpet
Detection in the app to
identify carpets and rugs for
the robot to avoid when it
mops.
Search for SharkClean in the app store and download the app to your smartphone.
WI-FI TROUBLESHOOTING
• To use the app, your phone must be connected
to a 2.4GHz network. The app will only work on a
2.4GHz network.
• Typical home Wi-Fi networks support both 2.4GHz
and 5GHz.
ERROR CODE
! (RED) + Wi-Fi indicator (RED Flashing)
! (Flashing red) + Wi-Fi (RED)
! + Wi-Fi (Flashing RED at the same time)
Wi-Fi (RED Flashing)
• Scheduling
Set whole-home cleans for
any time, any day.
• Control From Anywhere
Wherever you are, you're in
control of your robot.
• Cleaning Reports
Each time your robot cleans,
your app will generate a
cleaning report.
• Do not use a VPN or a proxy server.
• Make sure Wi-Fi isolation is turned off on the
router.
• DO NOT use Wi-Fi repeaters to connect your robot.
• If you cannot connect, visit sharkclean.eu.
PROBLEM
Wrong password for Wi-Fi
SSID cannot be found, try connecting again
Wrong user name or password for your SharkClean account
Cannot connect to Wi-Fi
s h a r kc l e a n . e u