shark AI ROBOT VACMOP Guide D'instructions page 20

USING THE SHARK® AI ROBOT VACMOP
IQ NAVIGATION AND AI LASER VISION
After setup is complete, follow instructions in the
app to help your robot conduct an Explore Run to
create an initial map of your home.
The robot will travel from room to room to identify
walls, furniture, and other obstacles as it cleans.
This run will take less time than a full cleaning, as it
doesn't cover the entire floor.
VACUUM ONLY INSTRUCTIONS
To vacuum, the fluid reservoir must NOT be
attached to the robot. Make sure the dustbin is
properly installed.
s h a r kc l e a n . e u
The robot's object detection technology helps it
navigate around obstacles taller than 8cm in height.
Clear away small objects that may interfere with the
cleaning path of your robot.
Create no-go zones in the app to block off areas you
do not want the robot to enter. You can set up no-go
zones around small objects, or use them to block off
large areas.
NOTE: Be sure to charge the robot completely before
its first cleaning so that it can explore, map, and clean
as much of your home as possible. It may take up to 6
hours to fully charge your robot.
NOTE: Avoid moving the dock. If it is relocated, the
robot may not be able to find its way back to the dock.
If the robot is relocated while in use, it may not be able
to follow its intelligent cleaning path, or find its way
back to the dock.
USING THE SHARK® AI ROBOT VACMOP
WET MOPPING SETUP
NOTE: Before it can mop, the robot MUST complete its Explore Run and an initial vacuuming run, and Carpet
Detection must be set up in the app.
Attach the mop pad by inserting the flat edge of the
pad through the slot in the reservoir. Pull the mop pad
all the way through the slot until it is securely inserted.
Lift open the fill cap on the top of the reservoir. Fill
with room temperature water, to the MAX fill line.
Close the cap and make sure it is properly sealed.
Secure the pad to the back of the reservoir.
Firmly push the reservoir into the back of the robot,
behind the dustbin, and ensure both latches click
into place. The water droplet icon on the robot
will illuminate white when the reservoir is inserted
properly.
s h a r kc l e a n . e u