AEG L 60270 MFL Notice D'utilisation page 14

14 www.aeg.com
10.5 Starting a programme
without the delay start
Press button Start/Pause to start the
programme.
The relevant indicator stops to flash and
stays on.
The programme starts, the door is
locked. The display show the indicator
.
The drain pump can operate
for a short time when the
appliance fills water.
10.6 Starting a programme
with the delay start
1. Press button Delay Start again and
again until the display shows the
delay you want to set.
2. Press button Start/Pause.
The appliance starts the countdown of
the delay start.
When the countdown is completed, the
programme starts automatically.
Before you press button
Start/Pause to start the
appliance, you can cancel or
change the set of the delay
start.
10.7 Cancelling the delay start
To cancel the delay start:
1. Press button Start/Pause to set the
appliance to pause.
The related indicator flashes.
2. Press button Delay Start repeatedly
until the display shows .
3. Press button Start/Pause again to
start the programme immediately.
10.8 Interrupting a
programme and changing a
function
You can change only some options
before they operate.
1. Press button Start/Pause.
The related indicator flashes.
2. Change the function set.
3. Press the button Start/Pause again.
The programme continues.
10.9 Cancelling a running
programme
1. Turn the programme knob to Off to
cancel the programme.
2. Turn again the programme knob to a
new washing programme. At this
time you can also set the available
functions.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
10.10 Opening the door
When the appliance is working and
through the delay time, the door is
locked.
If, for any reason, it is necessary to open
it, firstly press button Start/Pause to set
the machine to pause.
If the indicator Door locked after a few
minutes goes off, the door can be
opened.
If the indicator Door locked stays on and
the door remains locked, this means that
the appliance is already heating or that
the water level is too high. In this case
the door cannot be opened.
If you cannot open the door but you
need to open it, turn the programme dial
to Off to switch the appliance off. After a
few minutes the door can be opened
(pay attention to the water level and
temperature !) .
After closing the door, it is necessary to
set the programme and the options
again. Press button Start/Pause to start
the programme again.
10.11 End of cycle
When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display comes on and the door
locked indicator goes off.