Anslut 018965 Mode D'emploi page 11

3. Connect the wires to the terminal block
as follows:
Brown
Yellow/green
Blue
4. Check that the gasket in the junction box
is correctly place in the slot in the lid.
5. Fasten the lid with the 6 screws.
NOTE:
The lamp should be installed by an
authorised electrician.
REMOVING THE LED MODULE
1. Remove the four screws on the front.
FIG. 1
2. Remove the glass and reflector.
FIG. 2
3. Remove the four screws holding the LED
module.
FIG. 3
4. Cut the wire to the LED module.
5. Remove the LED module.
FIG. 4
L - Live wire
- Earth
N - Neutral wire
EN
11