Télécharger Imprimer la page

Anslut 018965 Mode D'emploi page 10

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
EN
SAFETY INSTRUCTIONS
Only intended for outdoor use.
The lamp must only be installed by an
authorised electrician.
The patio lamp is only intended to be
used outdoors.
The lamp must be mounted on a fireproof
surface and for permanent use. It is not
intended to be used as a portable lamp.
Make sure that no one is underneath the
lamp when installing it.
The lamp must only be used intact, with
the lamp glass in place.
The lamp can get very hot when in use.
Make sure that it is not possible to touch
the lamp housing by mistake, and that
the lamp has cooled before handling it.
Before using the lamp for the first time it
should be checked by an electrician.
Disconnect the lamp from the mains
supply before repairs or maintenance.
The light source cannot be replaced. If it
stops working, the entire lamp must be
discarded.
The lamp should be installed by an
authorised electrician.
To avoid accidents in public places, take
local regulations and safety instructions/
warnings into consideration.
Only use an approved cable to connect
the lamp to the mains. The external cable
must as a minimum comply with the
requirements for cable type H05RN-F in
terms of its mechanical and electrical
properties, and the wires must have a
cross-sectional area of at least 1.0 mm².
WARNING!
New installations and extensions to existing
systems should always be carried out by
an authorised electrician. If you have the
necessary experience and knowledge
(otherwise contact an electrician), you can
replace power switches and wall sockets,
10
fit plugs, extension cords and light sockets.
Incorrect installation can result in fatal injury
and the risk of fire.
Symbols
Read the instructions.
Installed at least 1 metre
from the surfaces to be
illuminated.
Risk of electric shock.
Replace the lamp glass if
cracked.
Approved as per applicable
directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage
Output
Luminous flux
Colour temperature
Life span
Diffusion angle
Size
INSTALLATION
1.
Open the junction box. The lid is held in
place with 6 screws.
2.
Insert the mains cable through the cable
opening.
230 V ~ 50 Hz
50 W
6000 lm
5500 K
30000 h
130°
L50 x W21 x H8 cm

Publicité

loading