Publicité
Les langues disponibles
Les langues disponibles
Before performing cleaning and maintenance work,
place the appliance on a flat surface, unplug the
power cord and relieve any water pressure.
To ensure a trouble-free and long service life, comply with
these instructions:
1. Wash the water and high-pressure hoses, lances and
remaining accessories before assembling them;
2. Clean dust and sand from the couplings;
3. Clean the nozzle regularly.
Clean the water inlet filter regularly: once a month or more
often according to use.
1. Carefully loosen the hose connector, where the filter is
situated;
2. Remove the filter;
3. Wash the filter until it is completely clean;
4. Reinsert the water inlet filter into the hose connector and
fit it into the high-pressure washer.
The water inlet filter must always be fitted inside the water
inlet pipe to filter out sand and other impurities, as they will
damage the pump valves.
A clogged spray nozzle (17) causes a significant reduction
in water flow, causing the washer's motor to run
intermittently. When it happens, act as follows:
1. Turn the high-pressure washer off by setting the ON/OFF
switch to OFF position (3) and unplug the power cord
(10) from the socket;
2. Close the water supply tap;
3. Press the gun trigger (15) to release the water pressure;
4. Remove the lance;
5. Set the adjustable nozzle to narrow spray position (turn
the nozzle (18) counterclockwise all the way). This opens
up the blades;
6. Use the supplied cleaning needle. Insert the needle
inside the nozzle hole and move it forwards and
backwards until the nozzle is unclogged;
7. Tap the lance vertically until the debris come out at the
opposite end of the nozzle.
It is important that the nozzle is regularly inspected and
cleaned, using the supplied needle.
Pressure washer's water pumps need relatively low oil
maintenance.
However, in case of leak, stop the appliance immediately
and call technical assistance to repair the appliance.
Cleaning
Clean the washer after each use. Careful handling protects
the power tool and extends its service life.
Storage
The appliance should be stored in a dry place, especially in
winter, to avoid damages cause by ice.
1. After stopping the washer, remove all water from the
pump, press the gun trigger (15) until there's no water
coming out of the nozzle (17);
2. Disassemble high-pressure hoses, gun and lances;
3. Drain the water from all accessories and use a cloth to
clean hoses' external parts and other accessories,
4. Clean the water inlet filter and nozzle;
5. Put the cover on the water inlet filter (1);
6. Store the appliance in a clean and dry place.
The packaging is made up of recyclable materials,
which you can dispose on local recycling points.
Never dispose of power tools in your household
waste!
According to the European Directive 2012/19 /EC on
electrical and electronic equipment waste and its
transposition into national law, power tools must be
collected separately and delivered to the collection sites
provided for this purpose.
You can obtain information regarding the disposal of the
power tool through the person in charge for the recycling in
your city.
Tel.:
+351 256 248 826
E-mail:
international@centrallobao.pt
Website:
www.centrallobao.pt
Publicité
