Tools Needed - RIDGID R4031 Manuel D'utilisation

FEATURES
KNOW YOUR TILE SAW
See Figure 3.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
7 in. TILE CUTTING WHEEL - A 7 in. tile cutting wheel is
included with your saw.
WARNING:
Do not use cutting wheels rated less than the
speed of this tool. Failure to heed this warning
could result in personal injury.
ADJUSTABLE LASER ALIGNMENT SYSTEM - For more
accurate cuts, a laser guide is included with the tile saw.
When used properly, the laser guide makes accurate,
precision cutting simple and easy. Simply push the switch
to turn the laser on or off.

TOOLS NEEDED

The following tools (not included or drawn to scale) are needed for assembly and alignment:
FRAMING SQUARE
PHILLIPS SCREWDRIVER
FLATHEAD SCREWDRIVER
MITER GUIDE - The easy-to-read indicator on the miter
guide shows the exact angle for the desired cut.
MOTOR - This machine has a strong motor with sufficient
power to handle tough cutting jobs.
ON/OFF SWITCH - This saw has an easy access power
switch located on the saw arm. To lock the switch, install a
padlock (not included) through the hole in the switch. When
the lock is installed and locked, the switch is inoperable.
Store the padlock key in another location.
SLIDING TABLE - The sliding table allows the user to slide
the workpiece into the cutting wheel for accurate cuts.
SPLASH GUARD - The splash guard helps contain
overspray and mist.
WATER PUMP - The water pump provides water to the
cutting wheel.
UPPER WHEEL GUARD - Protects user from wheel contact
on upper portion of wheel.
C-CLAMP
10 — English
13 mm WRENCH
ADJUSTABLE WRENCH
COMBINATION SQUARE
Fig. 4