Publicité
Les langues disponibles
Les langues disponibles
The transport handle (6) may be set into two different
positions. In the superior position the handle will be higher,
in the inferior position, the handle will be lower.
1. Press the transport handle locking button (8);
2. Adjust the handle position;
3. Ensure the handle is locked. The locking button must be
out.
Before performing cleaning and maintenance work,
place the appliance on a flat surface, unplug the
power cord and relieve any water pressure.
To ensure a trouble-free and long service life, comply with
these instructions:
▪ Wash the water and high-pressure hoses, lances and
remaining accessories before assembling them;
▪ Clean dust and sand from the couplings;
▪ Clean the nozzle regularly.
Clean the water inlet filter regularly: once a month or more
often according to use.
1. Untighten and remove the water inlet filter (1);
2. Remove the filter element and wash it with tap water
until being completely clean;
3. Insert the filter element on the filter;
4. Tighten the filter in the water inlet.
The clog of the sprinkler nozzles causes a significant
reduction in the water flow, leading the machine to an
intermittent operation.
When it happens, act as follows:
1. Turn the high-pressure washer off by setting the ON/OFF
switch to OFF position (3) and unplug the power cord
from the socket;
2. Close the water supply tap;
3. Press the gun trigger (5) to release the water pressure;
4. Remove the lance;
5. Rotate the sprinkler nozzle counterclockwise, until its
limit, to open the vanes;
6. Insert a needle inside the sprinkler nozzle hole and move
it forwards and backwards until unclog. The impurities
must exit through the opposite extremity.
Pressure washer's water pumps need relatively low oil
maintenance.
However, in case of leak, stop the appliance immediately
and call technical assistance to repair the appliance.
Cleaning
Clean the washer after each use. Careful handling protects
the power tool and extends its service life.
Storage
The appliance should be stored in a dry place, especially in
winter, to avoid damages cause by ice.
1. After stopping the washer, remove all water from the
pump, press the gun trigger (5) until there's no water
coming out of the nozzle;
2. Disassemble high-pressure hoses, gun and lances;
3. Drain the water from all accessories and use a cloth to
clean hoses' external parts and other accessories,
4. Clean the water inlet filter and nozzle;
5. Put the cover on the water inlet filter;
6. Store the appliance in a clean and dry place.
The packaging is made up of recyclable materials,
which you can dispose on local recycling points.
Never dispose of power tools in your household
waste!
According to the European Directive 2012/19 /EC on
electrical and electronic equipment waste and its
transposition into national law, power tools must be
collected separately and delivered to the collection sites
provided for this purpose.
You can obtain information regarding the disposal of the
power tool through the person in charge for the recycling
in your city.
Tel.:
+351 256 248 826
E-mail:
international@centrallobao.pt
Website:
www.centrallobao.pt
Publicité
