Operation; Checking Scope Of Delivery; Installation Site; Operation Notes - HOLZMANN MASCHINEN DSM150 Manuel D'instructions

15

OPERATION

15.1

Checking Scope of Delivery

Always note visible transport damage on the delivery note and check the machine immediately
after unpacking for transport damage or missing or damaged parts. Report any damage to the
machine or missing parts immediately to your retailer or freight forwarder.
15.2

Installation site

NOTE: The floor or worktable at the installation site must be able to bear the load of the machine.
The minimum space required for the machine is determined by the dimensions of the machine
plus a safety area around the machine. Select a flat, solid surface with appropriate space for
installation. When setting up the machine, also take into account the working area required to
process workpieces. The base of this unit has mounting holes that allow it to be attached to a
workbench/machine stand (e.g.: Holzmann DSMMS1) to prevent it from moving during operation
and causing accidental injury or damage.
(DSMMS1)
15.3 Operation
Avoid touching the grinding wheel and the workpiece immediately after use as they
become very hot.

15.3.1 Operation notes

Let the grinding stone come to full speed before beginning the grinding process.
Do not overload the machine! A good approach to know when you overload the machine: When
the grinding stone looses speed due to workpiece pressure.
DO NOT USE THE MACHINE FOR ANY KIND OF CUTTING OPERATIONS!
Make it a habit to operate the machine in a position standing slightly next to the machine and not
exactly in front of the grinding stone. Always check the tightening knobs of the tool rest if
tightened well. Always check the gap between tool rest and grinding stone. It should be around ~
1-2mm. When grinding dry, you should always wear safety goggles and safety gloves.
Check the fixing nut of the grinding stone regularly if tightened well. If the machine is used
frequently, we strongly advice to connect the grinding machine to a dust collection system
suitable for collecting metal dust.

15.3.2 Starting / stopping the machine

HOLZMANN MASCHINEN GmbH
C A U T I O N
You can switch the machine on and off with the on/off switch
Turn it on: Press button (1)
Turn it off: Press button (2)
www.holzmann-maschinen.at
OPERATION
DSM150, DSM175, DSM200, DSM250
23