Operation; Before First Use; Sharpening; Grinding Angle Setting - HOLZMANN MASCHINEN NTS 250 Manuel D'utilisation

15

OPERATION

Device to be operated in a perfect state only. Inspect the device visually every time it is to be used.
Check in particular the safety equipment, electrical controls, electric cables and screwed connection
for damage and if tightened properly. Replace any damaged parts before operating the device.
15.1 Operation
Perform all machine settings with the machine being
disconnected from the power supply!

15.1.1 Before first use

Water reservoir:
 Fill the water reservoir completely with
water
 The grinding wheel must be saturated
with water!
 The grinding wheel material absorbs
water, so the level should be checked
regularly. If necessary refill the water
reservoir with water!
Polishing wheel:
Cover the surface of the polishing wheel with a thin layer of polishing paste

15.2 Sharpening

The angle guide helps to identify and maintain the cutting angle on a variety of tools.

15.2.1 Grinding angle setting

 Place the tool (3) in the tool rest (2)
and fix with the fixing screws
 Insert the tool rest over the universal
support (1)
 The distance from the tool rest to the
grinding wheel is intended to be as low
as possible in order to control the
sharpening process optimally!
 Place the angle guide (4) on the
grinding wheel with the desired angle
notch against the wheel and adjacent to
the universal support
 Adjust the positioning of the tool and
the universal support height as
necessary so that the sharpened edge
of the tool is flat against both the
grinding wheel (5) and the angle edge
on the angle guide.
HOLZMANN MASCHINEN GmbH
W A R N I N G
www.holzmann-maschinen.at
OPERATION
23
NTS 250 / NTS 250PRO