Emerson 4th AVENUE CF766LBQ00 Mode D'emploi page 6

3. Ceiling Fan Assembly
3.4
Position the Upper Housing, aligning its two Notched
Areas, the Six Screw Holes and the Reverse Switch
Hole onto the Upper Motor Housing Flange (Figure 4).
3.5
Place the Upper Housing Plate so that the two Notched
Areas align with the two Studs on the Motor Coupler.
Aligning the six Screw Holes of the Upper Housing
Plate onto the Upper Housing.
Securely attach the Upper Housing Plate to the Upper
Housing by using the six #8-32 x 1/2" Pan Head
Screws with Lockwashers (supplied) (Figure 5).
3.6
Remove the Hanger Ball by loosening the Set Screw in
the Hanger Ball until the Ball falls freely down the
Downrod (Figure 6).
Remove the Pin from the Downrod, then remove the
Hanger Ball.
Retain the Pin and Hanger Ball for reinstallation in
Step 3.12.
NOTE: Do not loosen the Screw holding the Green
Ground Wire.
(Continued)
NOTCHED
AREAS (2)
UPPER
HOUSING
Figure 4
#8-32 x 1/2" PAN
HEAD SCREW S WITH
LOCKWASHER S (6)
Figure 5
PIN
PHILLIPS HEAD SET SCREW (LOOSENED)
Figure 6
6
REVERSE
SWITCH
HOLE
MOTOR COUPLER
STUDS (2)
REVERSE
SWITCH
UPPER
HOUSING
PLATE
MOTOR
COUPLER
MOTOR
COUPLER
STUDS (2)
GREEN GROUND WIRE
DOWNROD
HANGER BALL
ETL Model No.: CF766L