Emerson 4th AVENUE CF766LBQ00 Mode D'emploi page 13

5. How to Wire Your Ceiling Fan
5.3
Securely connect the Supply White (neutral) Wire to the
Receiver White (AC IN N) Wire using the Wire
Connector (supplied) (Figure 19).
Securely connect the Fan Motor White Wire to the
Receiver White (TO MOTOR N) Wire using the Wire
Connector (supplied) (Figure 19).
5.4
Securely connect the Supply Black Wire (hot) Wire to
the Receiver Black (AC IN L) Wire using Wire
Connector (supplied) (Figure 20).
Securely connect the Fan Motor Black Wire to the
Receiver Red (TO MOTOR L) Wire using Wire
Connector (supplied) (Figure 20).
Securely connect the Fan Motor Blue Wire to the
Receiver Blue (FOR LIGHT) Wire using Wire
Connector (supplied) (Figure 20).
5.5
After Connections have been made, turn Leads upward
and carefully push Leads into the Outlet Box, with the
White and Green Leads on one side of the Outlet Box
and position the Black and Blue Leads on the other
side of the Outlet Box (Figure 21).
Position the Antenna Wire on top of the Receiver. Slide
the RCFP Receiver completely onto the Hanger Ball,
nestled in the Hanger Bracket (Figure 21).
WARNING
!
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until blades are in place. Noise and fan
damage could result.
RECEIVER
WHITE WIRE
SUPPLY
WHITE WIRE
(NEUTRAL)
Figure 19
SUPPLY
BLACK
FAN MOTOR BLACK WIRE
WIRE
FAN MOTOR BLUE WIRE
Figure 20
ANTENNE
WIRE
TUCK ALL WIRES
INTO OUTLET BOX
Figure 21
13
Please contact 1-800-654-3545 for further assistance
(Continued)
RECEIVER
WHITE WIRE
FAN MOTOR
WHITE WIRE
RECEIVER
BLACK WIRE
RECEIVER
RED WIRE
RECEIVER
BLUE WIRE
OUTLET BOX
SLIDE RECEIVER
INTO HANGER
BRACKET
emersonfans.com
ETL Model No.: CF766L