Rizzoli T Série Manuel D'utilisation page 89

the ash door, allows the entrance of further com-
bustion air in the fire chamber, always taken from
the air inlet. The valve is closed in the right posi-
tion, it is open in the left position (see picture 19B).
This regulation is useful in presence of chimneys
with poor draft or in the cases in which a bigger
amount of primary air is needed.
When the thermostove is cold, we suggest to close
the lever below the fire door and set the primary
Condition
Starting
Fast heating
Slow heating
Table 3 – Regulations of the thermostove according to the different usages.
WARNING! When loading wood, consider a gap of few millimetres between wood and
glass, in order to avoid overheating of the glass that could cause breakings.
Picture 18 – Regulation of the air intake lever. The valve is open in correspondence of the position indicated by
letter "A" while it is closed in the position indicated with letter "B".
air regulator to value 0 and close the auxiliary pri-
mary air regulation, in order to limit the undesired
air flow that may cause an anticipated cooling of
the device and the room. This operation is particu-
larly important when the external air intake of the
thermostove is directly connected. Generally, for
an optimal working of the device, it is suggested
to follow the indications for the regulation of air
reported in table 3.
Air intake level
Open
Open
Half open Half open (3/4)
A
B
87
Draft regulator
Open
Open (7/8)
Grill
-
Low
Low