of 80 cm2. On demand, Rizzoli can give specific
valves which can allow the automatic opening of
the air intake only when it is necessary for the cor-
rect working of the thermostove, in order to war-
rant a maximum depression of 4 Pa in the place of
installation.
The wood fired thermostove can also be connect-
ed so that the oxidising air comes directly from
A
Picture 11 - Possible connections of the air intake of the thermostove. A = External air intake not connected
B = External air intake on the floor C = External air intake on the wall
To make the connection easier we suggest to make
the external air intake on the floor in correspond-
ence with the thermostove, or on the wall through
WARNING! Aspiring hoods or extracting air fans in the room may generate problems
to the device if there is not a suited air intake or in case of air intake sub-dimensioned.
B
Picture 12 – Rear sight of the thermostove and specifies for the connection with the air intake.
Models
A
T Basic
382
T Chef
382
Table 2 - Dimensions for the connection of the external air intake. Dimensions in mm.
C
B
C
H
100
245
56
100
245
56
outside. In this way, for the thermostove it is not
necessary another air intake in the room of instal-
lation. To make this it is necessary to prepare a
conduct connected directly with the external part
of the house and make a direct connection with
the air intake of the stove. The air intake of the
stove is located in the lower part. For the connec-
tion, we suggest to use a flexible pipe.
B
D
the rear part of the stove (see picture 12 and table
2).
A
Ø
95
95
79
C
H