Functions And Displays; Function Of The Leds - Abus FUBW50120 Instructions D'installation Et D'utilisation

Functions and displays

Function of the LEDs

LED layout:
Green
After the batteries have been inserted, the red and green LEDs should flash and display the
version number. The red LED will display the main version and the green LED the minor version.
Example:
Green
6x
Software version: v1.6
The yellow LED will then briefly flash, followed by four flashes from the red LED.
The IR programming is active if the red LED flashes 4 times.
Hold the LED of the motion detector close to the IR receiver of the wireless extension
(RFX).
See also "Step 3: Programming the motion detector"
Now the LEDs should flash in sequence from left to right and back again. This lasts for 60 s and
confirms the stabilisation of the detector after switching on.
For the next 30 minutes, the detector is in walk test mode. The LEDs indicate detection and
transmission as follows.
Green
IR detection
Note:
The 3-minute rest period is not active during the walk test period.
After the 30-minute walk test period has elapsed, the LEDs are deactivated.
• to extend battery life
• to prevent someone from identifying the surveillance partition during the day when the alarm
panel is deactivated.
Red
Red
1x
Red
Confirmed IR and microwave
detection
Wireless emission
Functions and displays
Yellow
Yellow
Yellow
Microwave detection
55 | E N