Step 2: Installing The Motion Detector - Abus FUBW50120 Instructions D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 62

Step 2: Installing the motion detector

• Open the housing by removing the screw on the bottom of the detector and taking off the
front housing panel.
• Select the desired variant with the jumper connected to CON1 A
o Standard (Jumper not connected to both contacts)
o Pet-proof (Jumper connected to both contacts)
Note:
The selection must be made before inserting the batteries.
When changing the variant, remove the batteries beforehand and reinsert the batteries
afterwards.
• Mount the detector as described in step 1 either on the wall or in the corner. To do this, use
the holes provided on the rear housing panel.
• Only use corresponding dowels and screws for the installation.
Danger
Installation
51 |
E N

Publicité

Table des Matières
loading

Table des Matières