Care And Cleaning - AEG FAVORIT 54000 I Notice D'utilisation

To change the selection when the washing programme operates, it is necessary to cancel
the programme.
• At the same time press and hold the buttons Multitab and Delay until:
– The time of the last set washing programme flashes in the display
– The indicators of the phases of the washing programme come on.
Make sure that there is detergent in the detergent dispenser before you start a new wash-
ing programme.
End of the washing programme
The display shows a zero and the phase indicators are off when the washing programme
is completed.
1. Deactivate the appliance.
2. Open the appliance door.
3. For better drying results, keep the door ajar for some minutes.
If you do not deactivate the appliance at the end of the washing programme, the appli-
ance stays on standby.
• To decrease energy consumption during the standby, after three minutes from the end
of the washing programme:
– All indicators go off
– The display shows one horizontal bar.
Press one of the buttons, the display and the indicators come on again.
Remove the items from the baskets
• Let the dishes become cold before you remove them from the appliance. Hot dishes
can be easily damaged.
• First remove the items from the lower basket, then from the upper basket.
• There can be water on the sides and on the door of the appliance. Stainless steel be-
comes cool more quickly than the dishes.

CARE AND CLEANING

To remove and clean the filters
Dirty filters decrease the washing results. Make a check at intervals and if necessary,
clean them.
The appliance has three filters:
• Coarse filter (A)
• Microfilter (B)
All manuals and user guides at all-guides.com
Care and cleaning 43