KENT Razor 20 Instructions D'utilisation page 6

ENGLISH INSTRUCTIONS FOR USE
WARNING!
– Before using the battery charger, ensure that frequency and voltage values, indicated on the machine serial
number plate, match the electrical mains voltage.
– Do not pull or carry the machine by the battery charger cable and never use the battery charger cable as
a handle. Do not close a door on the battery charger cable, or pull the battery charger cable around sharp
edges or corners. Do not run the machine on the battery charger cable.
– Keep the battery charger cable away from heated surfaces.
– Do not charge the batteries if the battery charger cable or the plug are damaged. If the machine is not
working as it should, has been damaged, left outdoors or dropped into water, return it to the Service Center.
– To reduce the risk of fi re, electric shock, or injury, do not leave the machine unattended when it is plugged
in. Before performing any maintenance procedure, disconnect the battery charger cable from the electrical
mains.
– Do not smoke while charging the batteries.
– Always protect the machine against the sun, rain and bad weather, both under operation and inactivity
condition. Store the machine indoors.
– Do not allow to be used as a toy. Close attention is necessary when used near children.
– Use only as shown in this Manual. Use only KENT's recommended accessories.
– Take all necessary precautions to prevent hair, jewelry and loose clothes from being caught by the machine
moving parts.
– Do not leave the machine unattended without being sure that it cannot move independently.
– Do not use the machine on slopes with a gradient exceeding the specifi cations.
– Do not use the machine in particularly dusty areas.
– While using this machine, take care not to cause damage to people or objects.
– Do not bump into shelves or scaffoldings, especially where there is a risk of falling objects.
– Do not put any can containing fl uids on the machine.
– The machine operating temperature must be between +32°F and 104°F (0°C and +40°C).
– The machine storage temperature must be between +32°F and 104°F (0°C and +40°C).
– The humidity must be between 30% and 95%.
– Do not use the machine as a means of transport.
– Do not use the machine on slopes with an inclination higher than 2%.
– Do not allow the brushes to operate while the machine is stationary to avoid damaging the fl oor.
– In case of fi re, use a powder fi re extinguisher, not a water one.
– Do not tamper with the machine safety guards and follow the ordinary maintenance instructions
scrupulously.
– Do not allow any object to enter into the openings. Do not use the machine if the openings are clogged.
Always keep the openings free from dust, hairs and any other foreign material which could reduce the air
fl ow.
– Do not remove or modify the plates affi xed to the machine.
– If the machine is used according to the instructions, the vibrations are not dangerous. The machine
vibration level is less than 98.4 in/s
– This machine cannot be used on roads or public streets.
– Pay attention during machine transportation when temperature is below freezing point. The water in the
recovery tank or in the hoses could freeze and seriously damage the machine.
– Use the brushes and pads supplied with the machine and those specifi ed in the Instructions for Use
Manual. Using other brushes or pads could reduce safety.
– In case of machine malfunctions, ensure that these are not due to lack of maintenance. If necessary,
request assistance from the authorized personnel or from an authorized Service Center.
– If parts must be replaced, require ORIGINAL spare parts from a Dealer or Authorized Retailer.
– To ensure the proper and safe operation of the machine, have the scheduled maintenance, detailed in the
relevant chapter of this Manual, performed by the authorized personnel or an authorized Service Center.
– Carefully read all the instructions before carrying out any maintenance/repair procedure.
– Do not wash the machine with direct or pressurized water jets, or with corrosive substances.
– The machine must be disposed of properly, because of the presence of toxic-harmful materials (batteries,
etc.), which are subject to standards that require disposal in special centers (see Scrapping chapter).
4 9097063000(1)2007-06
2 (2.5 m/s 2 ) (98/37/EEC-EN 1033/1995).
RAZOR 20 - RAZOR 20T