Introduction; Target; How To Keep This Manual; Identification Data - KENT Razor 20 Instructions D'utilisation

ENGLISH

INTRODUCTION

NOTE
The numbers in brackets refer to the components shown in Machine Description chapter.
MANUAL PURPOSE AND CONTENTS
The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and
autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal.
Before performing any procedure on the machine, the operators and qualifi ed technicians must read this Manual carefully. Contact
KENT in case of doubts concerning the interpretation of the instructions and for any further information.

TARGET

This Manual is intended for operators and technicians qualifi ed to perform the machine maintenance.
The operators must not perform procedures reserved for qualifi ed technicians. KENT will not be responsible for damages coming
from the non-observance of this prohibition.

HOW TO KEEP THIS MANUAL

The Instructions for Use Manual must be kept near the machine, inside an adequate case, away from liquids and other substances
that can cause damage to it.

IDENTIFICATION DATA

The machine model and serial number are marked on the plate (34).
The machine model year is shown after the Date Code on the serial plate (A07 means January 2007).
This information is useful when requiring machine spare parts. Use the following table to write down the machine identifi cation data.
MACHINE model ...............................................................................
MACHINE serial number ...................................................................

OTHER REFERENCE MANUALS

– Electronic battery charger Manual, to be considered as integral part of this Manual
Moreover, the following Manuals are available:
– Service Manual (that can be consulted at KENT Service Centers)
– Spare Parts List (supplied with the machine)

SPARE PARTS AND MAINTENANCE

All necessary operating, maintenance and repair procedures must be performed by qualifi ed personnel or by KENT Service
Centers.
Only original spare parts and accessories must be used.
Contact KENT for service or to order spare parts and accessories, specifying the machine model and serial number.

CHANGES AND IMPROVEMENTS

KENT constantly improves its products and reserves the right to make changes and improvements at its discretion without being
obliged to apply such benefi ts to the machines that were previously sold.
Any change and/or addition of accessory must be approved and performed by KENT.

OPERATION CAPABILITIES

These scrubber-dryers are used to clean (scrubbing and drying) smooth and solid fl oors, in civil or industrial environment, under
safe operation conditions by a qualifi ed operator.
The scrubber-dryer cannot be used for moquette and carpet cleaning.

CONVENTIONS

Forward and backward, front and rear, left and right references are intended with the operator in driving position with the hands on
the handlebar (2).
2
INSTRUCTIONS FOR USE
9097063000(1)2007-06 RAZOR 20 - RAZOR 20T