Troubleshooting; Scrapping - KENT Razor 20 Instructions D'utilisation

ENGLISH

TROUBLESHOOTING

Trouble
The motors do not work; no warning light turns
on.
The machine does not move (only for RAZOR
20T).
The brushes do not work, the red warning light
(81c) is on.
The recovery water vacuuming is insuffi cient.
The solution fl ow to the brushes is insuffi cient.
The squeegee leaves marks on the fl oor.
NOTE
In case of battery charger malfunction, contact an authorized Service Center.
For further information refer to the Service Manual, available at any KENT Service Center.

SCRAPPING

Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
– Batteries
– Brushes/pads
– Plastic hoses and components
– Electrical and electronic components (*)
(*) Refer to the nearest KENT Center especially when scrapping electrical and electronic components.
22
INSTRUCTIONS FOR USE
The battery connector (12) is disconnected.
The batteries are completely discharged.
The machine has been turned on by using
the ignition key (80) and by keeping the
paddle (77) pressed.
The batteries are discharged.
The recovery water tank (21) is full.
The hose (15) is disconnected from the
squeegee.
The vacuum grid (36) is clogged or the fl oat
is stuck closed.
The squeegee (25) is dirty or the squeegee
blades are worn or damaged.
The tank cover is not properly closed, or the
gasket (31) is damaged.
The solution fi lter (24) is dirty.
There are debris under the squeegee
blades.
The squeegee blades are worn, chipped or
torn.
The squeegee has not been adjusted with
the handwheel (27).
9097063000(1)2007-06
Possible Cause
RAZOR 20 - RAZOR 20T
Remedy
Connect.
Charge the batteries.
Turn the ignition key (80) to "0", then try
to start the machine without pressing the
paddle (77).
Charge the batteries.
Empty the tank.
Connect.
Clean the grid or check the fl oat.
Clean and check the squeegee.
Close the cover properly or clean/replace
the gasket.
Clean the fi lter.
Remove the debris.
Replace the blades.
Adjust.