Machine Working Hour Check; Squeegee Cleaning - KENT Razor 20 Instructions D'utilisation

MACHINE WORKING HOUR CHECK

(Only if the machine is equipped with hour counter)
1. (Only for RAZOR 20T): Turn the ignition key (80) to "I".
2. Press the switch (73) and read on the hour counter (79) the total number of working hours (scrubbing/drying) performed by the
machine.
3. Press the switch (73) again.
4. Turn the ignition key (80) to "0".

SQUEEGEE CLEANING

NOTE
The squeegee must be clean and its blades must be in good conditions in order to get a good drying.
CAUTION!
It is advisable to wear protective gloves when cleaning the squeegee because there may be sharp debris.
1. Drive the machine on a level fl oor.
2. (Only for RAZOR 20T): Turn the ignition key (80) to "0".
(Only for RAZOR 20): Press the switch (71) and/or (73) to turn the machine off.
3. Lower the squeegee (25) with the lever (10).
4. Loosen the handwheels (26) and remove the squeegee (25).
5. Disconnect the vacuum hose (15) from the squeegee.
6. Wash and clean the squeegee (Fig. 4). In particular, clean the compartments (A, Fig. 4) and the vacuum hole (B) from dirt
and debris. Check the front blade (C) and the rear blade (D) for integrity, cuts and tears; if necessary replace them (see the
procedure in the following paragraph).
7. Assemble the squeegee in the reverse order of disassembly.
RAZOR 20 - RAZOR 20T
INSTRUCTIONS FOR USE
9097063000(1)2007-06
ENGLISH
17