User Group; Agreement; Obligation Of The Shop Owner/Operator - Bosch RSCD 2100 Notice Originale

en | 20 | RSCD 2100 | Important notes
¶
Do not use the mirror as a support.
¶
Use only the cam to move the mirror; do not tilt it by
hand, as the mirror's springs can be over-stretched.
¶
Operate the height adjustment and tilt adjustment
only from behind and in sequence.
¶
Fit and check the safety systems immediately fol-
lowing completion of maintenance and repair work.
¶
Always re-tighten bolted joints to the specified
torque after maintenance and repair work.
¶
Have Bosch Customer Service check the unit every
2 years to ensure adjustment accuracy (e. g. to ISO
9000). Use suitable measuring equipment to check
the tilt position of the mirror. A digital spirit level
will a resolution of 0.05° in the appropriate measu-
ring range is recommended.
¶
A restraint must be attached in the correct manner
to stop the base slide gauge from dropping to the
end stop in the event of uncontrolled dropping.
An important safety function to prevent possible
injuries.
¶
Laser alignment unit is adjusted. Rotating the laser
module in the mount results in misadjustment and
further use of the adjustment unit is then no lon-
ger permitted. Adjustment is possible only in the
manufacturer's plant.
2.2

User group

The product may be used only by skilled and instructed
personnel. Apprentices or personnel undergoing trai-
ning, induction or instruction may only use the product
under the continual supervision of an experienced per-
son.
2.3

Agreement

By using the product you agree to the following condi-
tions:
Copyright
Software and data are the property of
Robert Bosch GmbH or its suppliers and protected
against copying by copyright laws, international agree-
ments and other national legal regulations. Copying
or selling of data and software or any part thereof is
impermissible and punishable; in the event of any in-
fringements Robert Bosch GmbH reserves the right
|
1 690 386 085 2018-08-21
to proceed with criminal prosecution and to claim for
damages.
Liability
All data in this program is based - where possible - on
manufacturer and importer details. Robert Bosch GmbH
does not accept liability for the correctness and com-
pleteness of software and data; liability for damage
caused by faulty software and data is ruled out. In any
event, liability on the part of Robert Bosch GmbH is
limited to the amount actually paid by the customer for
the product concerned. This exemption from liability
does not apply to wilful damage or damage arising from
gross negligence on the part of Robert Bosch GmbH.
Warranty
The use of unapproved hardware and software will re-
sult in a modification of our products and thus to the
exclusion of any liability or warranty, even if such hard-
ware and software have been removed or deleted again
in the interim.
No modifications may be carried out on our products.
Our products may only be used with genuine accesso-
ries and genuine spare parts. Otherwise, all warranty
claims will be rendered null and void.
2.4 Obligation of the shop owner/opera-
tor
The shop owner/operator is obliged to ensure that all
measures geared towards the prevention of accidents,
industrial diseases, labor-related health risks are taken
and measures towards making the workplace fit for peo-
ple to work in are carried out.
Basic rules
The shop owner/operator is obliged to ensure that all
electrical equipment and operating material is set up, mo-
dified and maintained by skilled electricians only or under
the guidance and supervision of a skilled electrician in
accordance with electrical engineering principles.
Robert Bosch GmbH