Generac OneWASH Mode D'emploi page 8

• Keep exhaust gas from entering a confined area
through windows, doors, ventilation intakes, or other
openings. Warn any occupants inside about the symp-
toms of carbon monoxide so they know to move to
fresh air if they begin to feel ill.
• The use of a carbon monoxide detector inside any
occupied premises between the power washer and the
occupant is recommended.
• NEVER start or run engine indoors, in a vehicle, or in
an enclosed area, even if windows and doors are open.
• Use a respirator or mask whenever there is a chance
that harmful gas or vapors may be inhaled.
• Read all instructions with respirator or mask so you are
certain the respirator or mask will provide the neces-
sary protection against inhaling harmful gas or vapors.
If you begin to experience any of the CO symptoms
listed above, IMMEDIATELY move to fresh air.
2.1.2 — Fluid Injection Hazard
NEVER aim spray gun at people, animals, or
electrical devices. Serious injury or death will
result. ALWAYS point spray gun in safe direc-
tion, squeeze spray gun trigger to release
high pressure, every time you stop engine.
Engage trigger lock when not in use.
• The high pressure stream of water that this equipment
produces can cut through skin and its underlying tis-
sues, leading to serious injury, possible amputation or
death. Spray gun traps high water pressure, even
when engine is stopped and water is disconnected,
which can cause injury.
• NEVER allow CHILDREN to operate power washer or
play nearby. This is NOT a toy.
• NEVER repair high pressure hose. Replace it.
• NEVER repair leaking connections with sealant of any
kind. Replace o-ring or seal.
• NEVER connect high pressure hose to nozzle exten-
sion.
• Keep high pressure hose connected to pump and
spray gun while system is pressurized.
• NEVER secure spray gun in open position.
• NEVER leave spray gun unattended while machine is
running.
• NEVER use a spray gun which does not have a trigger
lock or trigger guard in place and in working order.
• Always be certain spray gun, nozzles and accessories
are correctly attached.
4
2.1.3 — Electrical Shock Hazard
Risk of electrocution.
Contact with power source can cause electric
shock or burn.
• NEVER spray near power source.
2.1.4 — Hot Surfaces Hazard
Contact with muffler area can result in
serious burns. Exhaust heat/gases can
ignite combustibles, structures or
damage fuel tank causing a fire.
• DO NOT touch hot parts and AVOID hot exhaust
gases.
• Allow equipment to cool before touching.
• Keep at least five (5) feet (152 cm) of clearance on all
sides of power washer including overhead.
• It is a violation of California Public Resource Code,
Section 4442, to use or operate the engine on any for-
est-covered, brush-covered, or grass-covered land
unless the exhaust system is equipped with a spark
arrester, as defined in Section 4442, maintained in
effective working order. Other states or federal jurisdic-
tions may have similar laws. Contact the original equip-
ment manufacturer, retailer, or dealer to obtain a spark
arrester designed for the exhaust system installed on
this engine.
• Replacement parts must be the same and installed in
the same position as the original parts.
Safety
OneWASH™ Power Washer