Panasonic HL-CX667S Mode D'emploi Et Notice D'installation page 25

Do not repair or replace any part of the appliance unless specifically
recommended in the manual�
All other servicing should be done by a qualified technician. This may reduce the risk
of personal injury and damage to the oven.
Never modify or alter the construction of the appliance by removing panels, wire
covers, screws, or any other part of the appliance.
Wiring Connections
Be sure your appliance is properly installed and grounded by a qualified technician. Ask
your dealer to recommend a qualified technician or an authorized repair service.
This appliance is manufactured with a green GROUND wire connected to the oven chassis.
After making sure that the power has been turned off, connect the flexible conduit from
the oven to the junction box using a U.L. listed conduit connector. Figures 1 and 2 and the
instructions provided below present the most common way of connecting the ovens.
Your local codes and ordinances, of course, take precedence over these instructions.
Complete electrical connections according to local codes and ordinances "WARNING" Risk
of Electric Shock, frame grounded to neutral of appliance through a link.
Grounding through the neutral conductor is prohibited for new branch-circuit installations
(1996 NEC); mobile homes; and recreational vehicles, or in an area where local codes
prohibit grounding through the neutral conductor. For installations where grounding through
the neutral conductor is prohibited:
•
Disconnect the ground from the neutral at free end of conduit;
•
Use grounding terminal or lead to ground unit; and
•
Connect neutral terminal or lead to branch circuit neutral in usual manner.
■
3-Wire Branch Circuit
Refer to Figure 1, where local codes allow
the connection of GROUND wire from the
oven to the branch circuit NEUTRAL wire
(gray or white colored wire):
•
If local codes permit, connect the green
GROUND wire from the oven and the
white wire from the oven to the branch
circuit NEUTRAL wire (gray or white
colored wire).
•
Connect the red and black leads from the
oven to the corresponding HOT Wires in
the junction box.
•
Connect the local codes and power
supply codes using a terminal.
•
The terminal uses a thing adapting to the
wire of the cord.
All manuals and user guides at all-guides.com
CAUTION
Junction box
Red wires
White wires
green wire
Grounded Neutral
Cable from
power supply
Bare or
Cable
from oven
Figure 1
Black wires
U.L.-listed conduit
connector
EN-23