Panasonic HL-CX667S Mode D'emploi Et Notice D'installation page 24

Installation Instructions
Wiring Requirements
When making the wire connections, use the entire length of the conduit provided (130 cm
(51 3/16 in.)). The conduit must not be cut.
Before making connections make sure the power is off and read and observe the following:
1. A separate 3-wire or 4-wire, single phase, 120 V/240 V, 60 Hz or 120 V/208 V, 60 Hz
branch circuit is required for the oven.
2. The oven must be connected with Copper or Aluminum wire.
3. Wiring must conform to Canadian Electrical Code C22.1- latest edition.
4. Wire size (Copper or Aluminum wire) and connections must be suitable for the rating of
the appliance as per the National Electrical Code requirements. The flexible armored
cable extending from the oven should be connected directly to the junction box.
5. The junction box should be located so as to allow as much slack as possible between
the junction box and the oven so it can be moved if servicing is ever required.
6. A U.L. listed conduit connector must be provided at each end of the power supply cable.
ELECTRICAL SHOCK HAZARD
Failure to follow these instructions could result in serious injury or death.
The electrical power to the oven branch circuit must be shut off while line
connections are being made�
Electrical ground is required on this appliance� The free end of the green wire
(the ground wire) must be connected to a suitable ground� This wire must
remain grounded to the oven�
Check with a qualified electrician if you are in doubt as to whether the
appliance is properly grounded�
Do not use an extension cord with this appliance�
If cold water pipe is interrupted by plastic, non metallic gaskets, union
connections or other insulating materials, DO NOT use for grounding�
DO NOT ground to a gas pipe�
DO NOT have a fuse in the NEUTRAL or GROUNDING circuit� A fuse in the
NEUTRAL or GROUNDING circuit could result in an electrical shock�
EN-22
All manuals and user guides at all-guides.com
WARNING
For Installer