Decommissioning; Switching Off The Appliance; Taking The Appliance Out Of Service - V-ZUG Iglu 60i Mode D'emploi

The compressor runs longer to cool the food quickly. This is
u
normal.
A LED on the bottom rear of the appliance (at the
compressor) flashes repeatedly every 5 seconds*.
→ There is a fault.
Please contact the after-sales service (see 6 Mainte-
u
nance) .
Excessive noise.
→ Due to the various speed steps, speed-regulated* compres-
sors can generate different running noises.
The sound is normal.
u
A bubbling and gurgling noise.
→ This noise comes from the refrigerant flowing in the refriger-
ation circuit.
The sound is normal.
u
A quiet clicking noise.
→ The noise is produced whenever the refrigeration unit
(motor) automatically switches on or off.
The sound is normal.
u
A hum. It is briefly a little louder when the refrigeration
unit (the motor) switches on.
→ Refrigeration increases automatically when the Fast-Freeze
function is activated, fresh food has just been placed in the
appliance or the door has been left open for a while.
This noise is normal.
u
The ambient temperature is too high.
→
Solution: (see 1.2 Appliance range of use)
u
A low hum.
→ The sound is produced by air flow noise of the fan.
The sound is normal.
u
Vibration noises
→ The appliance is not standing firmly on the floor. As a result
objects and adjacent units start to vibrate when the refriger-
ator is running.
u Check the installation and realign the appliance.
Flow sound at the soft stop mechanism.
→ The noise is produced when the door is opened and
closed.
The sound is normal.
u
The temperature display indicates:
There is a fault.
→
Please contact the after-sales service (see 6 Mainte-
u
nance) .
Power failure flashes in the temperature display
highest temperature reached during power failure is indi-
cated in the temperature display.
→ The freezer temperature rose too high over the last hours
or days due to a power failure or power interruption. When
the power interruption is over, the appliance will continue to
operate in the last temperature setting.
u To cancel the display of the warmest temperature: press
Fig. 2 (5) .
alarm button
u Check the quality of the food. Do not consume spoiled food.
Do not re-freeze thawed food.
DEMO shines in the temperature display.
→ The demo mode is activated.
Please contact the after-sales service (see 6 Mainte-
u
nance) .
The outer surfaces of the appliance are warm*.
→ The heat of the refrigeration circuit is used to prevent
condensate from forming.
This is normal.
u
The temperature is not cold enough.
→ The door of the appliance is not properly closed.
Close the door of the appliance.
u
→ Insufficient ventilation.
* Depending on model and options
u
→
u
→
u
→
u
→
u
→
u
→
u
Dashes ("- -") are shown on the display.
→
u
The internal light does not come on.
→
u
→
u
→
Risk of injury due to electric shock!
There are live electrical parts under the cover.
u Only ever have the inside LED light replaced or repaired by
to
F0 F9
Risk of injury from LED bulb!
The light intensity of the LED light corresponds to hazard group
RG 2.
If the cover is defective:
. The u Do not look directly into the light from close range. It cause

8 Decommissioning

8.1 Switching off the appliance

u Press On/Off button
w A long beep is emitted. The temperature display is dark. The
w If the appliance cannot be switched off, the child lock func-

8.2 Taking the appliance out of service

u Empty the appliance.
u Switch off the appliance (see 8 Decommissioning) .
u Remove mains connector.
u Clean the appliance (see 6.2 Cleaning the appli-
u Leave the door open to prevent odour.
Decommissioning
Keep ventilation grille clear, and clean it.
The ambient temperature is too high.
Solution: (see 1.2 Appliance range of use) .
The appliance was opened too frequently or for too long.
Wait to see whether the appliance reaches the required
temperature by itself. If not, please contact the after sales
service (see 6 Maintenance) .
The temperature is incorrectly set.
Set the temperature to a colder setting and check after 24
hours.
The appliance is too close to a source of heat (stove, heater
etc).
Change the position of the appliance or the source of heat.
The appliance was not inserted properly into the recess.
Check whether the appliance was inserted correctly and
the door closes properly.
Too much fresh food was
Fast-Freeze.
Solution: (see 5.7 Fast-Freeze)
The freezing temperature has risen above zero degrees
because of a power cut or power interruption.
See also "Power failure" and "
The appliance is not switched on.
Switch the appliance on.
The door was open for longer than 15 minutes.
The internal light switches itself off automatically after about
15 minutes if the door is open.
The LED illumination is faulty or the cover is damaged:
WARNING
customer service or trained personnel.
WARNING
injury to the eyes.
Fig. 2 (1) for approx. 2 seconds.
appliance is switched off.
tion is active (see 5.1 Child proofing) .
ance) .
placed inside without
"
39