Cleaning And Storage - Cleanmaxx 00513 Mode D'emploi

EN
Assembly
1. Insert the rod with the drip protec-
2. Fit the Y tube (1) on the rod with the
3. Insert the two rods (3) into the Y
4. Attach the nylon balloon (2):
The device is disassembled in the re-
verse order.
Use
1. If you have not yet done so, attach
2. Pull the garment which is to be pressed over the nylon balloon
and do up the zip or buttons if necessary. Make sure that
– the legs of the nylon balloon fi t properly into the legs of the
trousers and are not twisted or scrunched up,
– all buttons on the garment (including the legs) are done up.
3. Spread the clamps (supplied with the main device) along the
bottom of the garment (at the front and back in each case on
the outsides) so that it is weighed down and will not go out of
shape when the nylon balloon is infl ated.
4. Operate the device as described in the instructions for use of
the main device.
5. Once the nylon balloon has infl ated, straighten out the garment
and smooth it down again.
6. Remove the garment from the nylon balloon after the comple-
tion of the drying/pressing process.
7. Switch off the main device, unplug it and allow it to cool.
Tips
• The drying/pressing process takes around 10 minutes for
spun-dried trousers. However, the length of time can vary
depending on the material and thickness of the material. We
recommend that you start with a shorter time and extend it if
necessary.
• In the case of trousers with a very small waist it may not be
possible to pull them over the attachment when it has already
been fi tted. In this case you proceed as follows:
– push the nylon balloon (2) upwards slightly, to enable access
to the rods (3),
– remove one of the two rods from the Y tube once more (1),
– draw the trousers over the two rods,
– now replace the rods in the Y tube and
– draw the nylon balloon over the mounting fl ange on the main
device again.
• Wide-apart buttons may result in the button strip crimping
slightly during pressing. Here it is advisable to smooth down
the button strip again by hand immediately after the pressing
process.
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany •
*) Calls to German landlines are subject to charges. The cost varies depending on the service provider.
tion into the recess which is provid-
ed for it on the main device.
drip protection.
tube.
– draw it over the two
rods.
– draw the elastic over the mounting
fl ange on the main device.
the nylon balloon (2) (see the "As-
sembly" chapter).
The nylon balloon should sit im-
mediately below the mounting
fl ange so that it can fully infl ate.
Customer Service / Importer:
• After the drying/pressing process any creases need to be
ironed out using a normal iron.

Cleaning and Storage

Before commencing the cleaning, note the safety instruc-
tions in the "Safety Instructions" chapter and the operating
instructions for the main device!
• Clean the device if necessary with a slightly damp cloth and
a little mild detergent if required. Then wipe down fully with a
dry cloth.
• Allow all parts to dry completely before you put them away.
• Store the article in a clean, dry place that is protected from
sunlight and is not accessible to children and animals.
Disposal
Dispose of the packaging material in an environmentally
friendly manner and take it to a recycling centre. Dispose
of the article in an environmentally friendly manner as well.
More information is available from your local authorities.
All rights reserved.
✆
+49 38851 314650 *)
Z 00513 M DS V1 0418
Instructions