Publicité
Les langues disponibles
Les langues disponibles
LOCk-ON / LOCk-OFF SLIDER
This sander is equipped with a switch that
allows you to lock it on for extended use,
and lock off to prevent accidental actuation.
LOCk ON
• To lock the tool ON, depress the paddle
(1) with one hand and push the slider (2)
right to the locked position with your other
hand as shown in Figure E.
• To stop the tool, push the slider left to the
unlocked position and release paddle.
LOCk OFF
• To lock the tool OFF, make sure the
paddle (1) is not depressed and push the
slider (2) right to the locked position. The
paddle cannot be depressed while switch
is in locked position.
• To unlock the paddle, push the slider left
to the unlocked position. The paddle can
now be depressed.
E
DUST COLLECTION
WARNING:
Collected sanding dust
from sanding surface coatings
(polyurethane, linseed oil, etc.) can self-
ignite in sander dust bag or elsewhere and
cause fire. To reduce risk, empty bag
frequently and strictly follow sander
manual and coating manufacturer's
instructions.
CAUTION:
Respiratory hazard.
Never operate this tool for wood sanding
unless the dust canister is in place.
Sanding dust exhaust may create a
breathing hazard.
WARNING:
Fire hazard. When
working on metal surfaces, do not use the
dust canister because sparks are
generated. Wear safety glasses and a dust
mask. Due to the danger of fire, do not use
your sander to sand magnesium surfaces.
Do not use for wet sanding.
Your sander comes equipped with a cloth
canister (6) to collect the dust generated
while sanding.
• To attach the canister to the sander, line
up the grooves (8) in the canister (6) with
the nubs (9) on the dust port (5). Ensure
the longer side (10) of the canister
opening is on the top side of the port.
• Slide the canister onto the dust port and
turn the canister clockwise to lock it in
place as shown in the insert of Figure F.
• To remove, turn the canister
counterclockwise and slide the canister off.
• To empty the canister, remove it from the
dust port and dump the sanding debris
into an appropriate trash receptacle.
F
hINTS FOR OPTIMUM USE
• Do not place your hands over the
ventilation slots.
• Do not exert too much pressure on the tool.
• Regularly check the condition of the
sanding sheet. Replace when necessary.
• Always sand with the grain of the wood.
• When sanding new layers of paint before
applying another layer, use extra fine grit.
• On very uneven surfaces, or when
removing layers of paint, start with a
coarse grit. On other surfaces, start with
a medium grit. In both cases, gradually
change to a fine grit for a smooth finish.
MAINTENANCE
Use only mild soap and damp cloth to clean
the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into
a liquid.
IMPORTANT: To assure product SAFETY
and RELIABILITY, repairs, maintenance
and adjustment should be performed by
authorized service centers or other qualified
service organizations, always using identical
replacement parts.
ACCESSORIES
WARNING:
not recommended for use with this tool
could be hazardous.
Recommended accessories for use with
your tool are available from your local dealer
or authorized service center. If you need
assistance regarding accessories, please
call: 1-800-544-6986.
SERvICE INFORMATION
All BlACK+DECKER Service Centers are
staffed with trained personnel to provide
customers with efficient and reliable power
tool service. Whether you need technical
advice, repair, or genuine factory replacement
parts, contact the BlACK+DECKER location
nearest you. To find your local service
location, call: 1-800-544-6986 or visit
www.blackanddecker.com
6
10
9
8
The use of any accessory
Publicité
