ESTEBAN PARIS ELESSENS Notice D'utilisation page 7

This diffuser combines high-quality fragrance diffusion and the elegance of ceramic, enhanced by luminous colour effects.
OVERVIEW
A
C
4
A: Ceramic upper part
C: Bottom part, water tank
1: Ceramic disk
2: Water level
3: Air outflow
4: Button
STARTING THE DIFFUSER
Read the below-mentioned instructions carefully before starting the diffuser.
1
STAGE 1
• Place the diffuser on a flat and stable surface away from the edge.
• Connect the electricity cable to the port at the back of the diffuser without plugging it in.
• Remove the upper part A. Pour water at room temperature into the container C. Do not exceed the maximum level
of 100ml. (Warning: the diffuser does not work if the water level is too low or higher than 100ml).
• Do not pour hot water into the container (risk of damage of sensitive components).
• Add 10 to 15 drops of Estéban refresher oils or essential oils, depending on the required intensity (the harshest and
most viscous essential oils should not be used as they may damage your diffuser).
-  Do not pour drops of refresher oils or essential oils into the container if there is no water in it as this
risks damaging the device.
- Wipe up any drops that may accidentally have fallen outside the container.
- An excess of refresher oils or essential oils could prevent the diffusion and damage the diffuser.
• Ensure the upper part A is placed completely straight on the base of the diffuser C.
• Do not move the diffuser once you have filled it.
DIFFUSER
maximum level 100ml
1
2
Bottom view
3
B: Electricity cable
ACCESSORIES
B
GB
7