Publicité
Les langues disponibles
Les langues disponibles
GAS COOKTOP INSTALLATION INSTRUCTIONS
Typical Under Counter Installation of an Electric Built-in
Oven with a Cooktop Mounted Above
All mounting hardware must be
used to secure the built-in oven to
the cabinets. Refer to the built-in
oven installation instructions.
208/240 Volt
grounded junction
box for built-in oven.
Cut an opening in wood base minimum 4"
(10.2 cm) x 4" (10.2 cm) to route armored
cable to junction box.
* If no cooktop is installed
directly over the oven unit,
5" (12.7 cm) maximum is al-
lowed.
(For 30" & 36" Models)
This cooktop may
be installed over
certain built-in elec-
tric oven models.
Junction box must
be located approx.
3" to the left of
the built-in oven
cutout.
OVEN SIZE
30"
(76,2 cm)
27"
(68,6 cm)
Side filler panels are necessary to iso-
late the unit from adjoining cabinets.
Panel height should allow for installa-
tion of approved cooktop models. See
"Typical Gas Cooktop Installation Over
an Electric Built-in Oven Installed Un-
der the Counter" on next page.
Unit will
overlap
cutout
(minimum)
edges by
4 1/2" (11.4 cm)
1" (2.5cm)
cutout dimensions (incHes (cm))
E
Min.
Max.
27 ¼"
28 ¼
(69,2 cm)
(71,8 cm)
27 ¼"
28 ¼
(69,2 cm)
(71,8 cm)
Figure 3
4
36"
(91.4 cm)
Min.
Use 3/4" (1.9 cm)
plywood, installed on
two runners, flush with
toe plate. Base must be
capable of supporting
150 pounds (68 kg) for
27" models and 200
pounds (90 kg) for 30"
models.
Max.*
F
Min.
Max.
28 ½
29"
(72,4 cm)
(73,7 cm)
24
/
25 ¼
7
8
(63,2 cm)
(64,1 cm)
G
23 ½
(59,7 cm)
23 ½
(59,7 cm)
Publicité
