Bosch BGS6 Serie Mode D'emploi page 48

26
Figure
If the plate filter is particularly dirty, it can also be
rinsed clean.
Turn the bottom part of the filter system clockwise
as far as the stop.
Remove the plate filter from the filter system.
Rinse the filter under running water.
When it has dried completely, insert the plate filter
into the filter system and lock the bottom part by
turning it anticlockwise.
Under normal circumstances, and the appliance is
used as intended for household cleaning, the plate fil-
ter does not need to be removed or cleaned manually
in order to achieve the optimum power level.
!
Do not brush the filter.
For simple dry cleaning, simply tap the filter around
the edge of the cap.
For more thorough cleaning, rinse the filter from
the outside with water, and allow it to dry comple-
tely before using it in the vacuum cleaner again.
27
Figure
a) Unlock the dust container and take it out of the
appliance.
b) Take the filter unit out of the dust container.
c) Clean the fluff filter.
When emptying the dust container, always check how
dirty the fluff filter is and, if necessary, clean it as
detailed in the "Cleaning the fluff filter" instructions.
Cleaning the fluff filter
The fluff filter should be cleaned at regular intervals
in order to ensure optimum operation of the vacuum
cleaner. It is usually sufficient to lightly shake or tap
out the filter housing when the dust container is emp-
tied in order to dislodge any particles of dirt.
!
Caution: the fluff filter must not be cleaned under
running water.
The (H)EPA filter is designed so that it does not need
to be replaced if the appliance is used as intended for
household cleaning. To ensure that the vacuum clea-
ner keeps working at its optimum performance level,
the (H)EPA filter should be rinsed clean after approx.
3 years. The filtering effect of this filter in maintained,
even though the filter surface may become discolou-
red.
46
Rinsing the (H)EPA filter
28
Figure
a) Open the exhaust grille by pressing the release
button.
b) Unlock the (H)EPA filter by pressing the locking tab
and remove it from the appliance.
c) Tap out the (H)EPA filter and rinse under running
water
d) Do not re-insert the (H)EPA filter into the appliance
until it has completely dried and then close the
exhaust filter compartment.
Cleaning instructions
Always switch off the vacuum cleaner and disconnect
the power cord from the mains before cleaning the va-
cuum cleaner. The vacuum cleaner and plastic acces-
sories can be cleaned with an ordinary plastic cleaner.
!
Do not use abrasive materials, glass-cleaning
agents or all-purpose cleaning products. Never im-
merse the vacuum cleaner in water.
Subject to technical modifications.
* Dependent on model