Eu Declaration Of Conformity - ABB M3BL 160 Mode D'emploi

1. INTRODUCTION

1.1 EU Declaration of Conformity

The products: 3-phase electric motors of the series
M3BL 160, 180, 200, 225, 250, 280 and 315
M3AL 90, 100, 112 and 132
M3BC 280, 315 and 355
M3BJ 225, 250, 280, 315, 355, 400 and 450
M3LJ 225, 250, 280, 315, 355, 400 and 450
M3EB 100, 132, 160, 200 and 250
M3EH 100, 132, 160, 200, 250 and 315
M3ET 250
M3FT 250, 280, 315, 355 and 400
M3LK 160
M3LL 280 and 315
M3RP 180, 200, 225, 250, 280, 315, 355, 400 and 450
The Manufacturer:
ABB Oy, IEC LV Motors
P.O. Box 633
Strömbergin puistotie 5A
FI-65101 Vaasa, Finland
This declaration of conformity is issued under the sole responsibility of the
manufacturer.
The products of the declaration as listed above are in conformity with the relevant
Union harmonization legislation:
Directive 2014/35/EU
The motors are in conformity with provisions of the harmonized standards which
thus comply with Principal Elements of the Safety Objectives for Electrical Equipment
stated in Annex I of said directive.
Directive 2011/65/EU
Motors are in conformity with the Directive 2011/65/EU and the amending Annex II
to this Directive of the Delegated Directive (EU) 2015/863 of the European Parliament
and of the Council on the restriction of the use of certain hazardous substances
in electrical and electronic equipment. Technical documentation based on the
harmonized standard EN IEC 63000:2018.
Energy Efficiency
IE class and markings, if indicated, are declared based on the standard EN IEC 60034-
30-2 and efficiency determined based on EN IEC 60034-2-3:2020.
The following standards are applied in relation to which conformity is declared:
EN 60034-1:2010, EN 60034-5:2001/A1:2007, EN 60034-6:1993, EN 60034- 7:1993/
A1:2001, EN 60034-8:2007/A1:2014, EN 60034-9:2005/A1:2007 and EN 60034-
14:2004:/A1:2007.
5
EN