Publicité
Installation Instructions
IMPORTANT SAFETY INSTRUCTIONS
For Your Safety
WARNING:
safety, remove house fuse or open
circuit breaker before beginning
installation. Failure to do so could result
in serious injury or even death.
All rough-in and spacing dimensions must be
met for safe use of your range. Electricity to the
range can be disconnected at the outlet without
moving the range if the outlet is in the preferred
location (remove lower drawer).
To reduce the risk of burns or fire when reaching
over hot surface elements, cabinet storage
space above the cooktop should be avoided. If
cabinet storage space is to be provided above
the cooktop, the risk can be reduced by installing
a range hood that sticks out at least 12.7 cm (5")
beyond the front of the cabinets. Cabinets
installed above a cooktop must be no deeper
than 33 cm (13").
Be sure your appliance is properly installed and
grounded by a qualified technician.
WARNING:
risk of tipping, the appliance must
be secured by properly installing
the Anti-Tip bracket packed with the
appliance.
If you pull the range out and away from the wall
for any reason, make sure the Anti-Tip bracket is
engaged when the range is pushed back against
the wall.
For personal
To reduce the
Electrical
Requirements
This appliance must be supplied with the
proper voltage and frequency, and connected
to an individual, properly grounded branch
circuit, protected by a circuit breaker or fuse
having amperage as noted on rating plate.
(Rating plate is located above the storage
drawer on the oven frame.)
We recommend you have the electrical wiring
and hookup of your range connected by a
qualified electrician. After installation, have the
electrician show you where your main range
disconnect is located.
Check with your local utilities for electrical
codes which apply in your area. Failure to
wire your range according to governing codes
could result in a hazardous condition. If there
are no local codes, your range must be wired
and fused to meet the requirements of CAN/
CSA C22.2 No. O-M91 or latest edition.
You must use a three-wire, single-phase A.C.
208Y/120 Volt or 240/120 Volt, 60 hertz
electrical system. If you connect to aluminum
wiring, properly installed connectors approved
for use with aluminum wiring must be used.
• All ranges can tip
• Injury to persons could result
• Install anti-tip bracket
• See Installation Instructions
2
WARNING
packed with range
Publicité
