Publicité
Les langues disponibles
Les langues disponibles
1. Release the gun trigger (2);
2. Set the "ON/OFF" switch (7) to" OFF" position;
3. Close the water supply tap;
4. Press the gun trigger (2) to relieve any water pressure;
5. Place the locking button in the position that does not
allow triggering;
6. Wind the high-pressure hose (5) and place it in the
support;
7. Detach the quick connector from the supply hose;
8. Wind the water supply hose;
9. Unplug the power cord (12);
10. Wind up the power cord (12) and place it in the holder.
Never close the water supply tap off before turning
off the washer.
The water outlet pattern regulation is carried out through
the sprinkler nozzle (16).
1. Rotate counterclockwise for a thinner pattern;
2. Rotate clockwise for a wider pattern.
Always release the gun trigger (2) while regulating
the water outlet pattern.
A narrow-concentrated jet produces a stronger impact,
which results in deeper cleaning effect in a more
concentrated area. This type of jet should be used carefully,
as it can damage some surfaces.
A wider jet distributes the water impact over a larger area,
cleaning a larger area and reducing the risk of damage to
the surfaces to be cleaned.
The water outlet angle can be adjusted, between 0 and 60°.
The use of a spray angle equal to 45°, allows an efficient
removal of debris, due to the combination: impact force
and jet cleaning area;
Another factor that determines the water impact force is the
distance between the nozzle and the surface to be cleaned.
The impact force increases as the nozzle approaches the
surface.
Avoid cleaning windows with a narrow jet once it
might break the glass. Set the nozzle to a 45° spray
angle.
Before performing cleaning and maintenance work,
place the appliance on a flat surface, unplug the
power cord and relieve any water pressure.
To ensure a trouble-free and long service life, comply with
these instructions:
▪ Wash the water and high-pressure hoses, lances and
remaining accessories before assembling them;
▪ Clean dust and sand from the couplings;
▪ Clean the nozzle regularly.
Clean the water inlet filter regularly: once a month or more
often according to use.
1. Untighten and remove the water inlet filter (8);
2. Remove the filter element and wash it with tap water
until being completely clean;
3. Insert the filter element on the filter;
4. Tighten the filter in the water inlet.
The clog of the sprinkler nozzles (16) causes a significant
reduction in the water flow, leading the machine to an
intermittent operation.
When it happens, act as follows:
1. Turn the high-pressure washer off by setting the ON/OFF
switch to OFF position (7) and unplug the power cord
(12) from the socket;
2. Close the water supply tap;
3. Press the gun trigger (2) to release the water pressure;
4. Remove the lance;
5. Rotate the sprinkler nozzle (16) counterclockwise, until
its limit, to open the vanes;
6. Insert a needle inside the sprinkler nozzle hole and move
it forwards and backwards until unclog. The impurities
must exit through the opposite extremity.
Publicité
