Oase Eco Control Notice D'emploi page 4

- EN -
Information about these operating instructions
Welcome to OASE Living Water. You made a good choice with the purchase of this product Eco Control.
Prior to commissioning the unit, please read the instructions of use carefully and fully familiarise yourself with the unit.
Ensure that all work on and with this unit is only carried out in accordance with these instructions.
Adhere to the safety information for the correct and safe use of the unit.
Keep these instructions in a safe place! Please also hand over the instructions when passing the unit on to a new
owner.
Symbols used in these instructions
The warning information is categorised by signal words, which indicate the extent of the hazard.
W A R N I N G
 Indicates a possibly hazardous situation.
 Non-observance may lead to death or serious injuries.
N O T E
Information for the purpose of clarification or for preventing possible damage to assets or to the environment.
Scope of delivery
 A Description
1 AquaMax Eco Control
2 Retaining frame for fastening the device to the wall, or for fitting it to the ground stake or holding clip
3 Ground stake
4 Holding clip for fastening the device to the pump handle
Product Description
Eco Control can be used to control EGC-capable OASE pumps.
Features:
 Connection to the EGC socket of the pump.
 Illuminated display.
 Does not require a separate power supply.
 Control of the pump capacity, switching the Seasonal Function Control (SFC) and Dynamic Function Control (DFC)
on or off, selection of programmes.
 Allows display of the pump status and malfunctions.
Intended use
Eco Control, referred to as "unit", may only be used as specified in the following:
 Connection to OASE pumps with EGC connection, that are suitable for control via this device.
 Operation under observance of the technical data.
Installation and connection
Fastening the device to the pump
How to proceed:
 B
1. Fit the holding clip onto the pump handle.
2. Slide the device onto the holding clip.
3. Align the device.
Installing the device with the ground stake
How to proceed:
 C
1. Fully insert the ground stake into the ground.
2. Slide the device onto the ground stake.
3. Check its stability.
4