Operational Time; Racking Your Preamplifier; Battery Change For The Remote Control - Elipson REFERENCE Serie Manuel D'utilisation

OPERATIONAL TIME

The device is immediately functional when first put into operation.
Just set the rear power switch to " 1 " and press the front button,
so the center LED turns white. However, this device will offer an
optimal listening quality 30 minutes after it is turned on, the time
for the power and input stages to reach their optimal functional
temperature.

BATTERY CHANGE FOR THE REMOTE CONTROL

Your remote control is powered by a button battery CR2450
To replace it, simply remove the 6 screws (flat screwdriver) on the
back to remove the PCB. Replace the battery, place the PCB in its
place then tighten the 6 screws by hand.

RACKING YOUR PREAMPLIFIER

If you wish to place your preamplifier in a rack, you will find optional
brackets (2U) specifically designed for this device.
To mount a bracket, first loosen the two BTR screws on the edge
of the device. Let place the bracket so that it is flush with the front
panel. Screw the two BTR screws back into place, securing the
bracket to the device. Proceed in the same way for the opposite
bracket.
EN
51