Connect An Active Subwoofer; Connect Your Sources; Use And Navigation Controls - Elipson REFERENCE Serie Manuel D'utilisation

EN

CONNECT AN ACTIVE SUBWOOFER

The P1 preamplifier has two mono RCA/CINCH connections to
offer you a 2.1 configuration thanks to its low pass filter (400 Hz /
12 dB / octave). So you can use it with one or two subwoofers. To
do so, just connect one of the two RCA / CINCH analog outputs
"mono SUB" to your subwoofer or both RCA / CINCH analog outputs
"mono SUB" to the two subwoofers.

CONNECT YOUR SOURCES

Originally, you can connect one balanced/symmetrical source
and two unbalanced/symmetrical sources to the inputs on the
rear panel.
Be sure to respect the right and left channels between your
preamplifier and your sources to ensure a faithful stereo image.
The upgradeable nature of this unit will allow you to supplement its
features and source selection with a set of optional components
that can be easily built into the back of the unit.
Optional boards (included for P1F) :
- MPH II (RIAA input board - Phono MM & MC)
- MDAC I (32 bit/384 kHz (192 kHz S/PDIF Coaxial) 3 input digital
inputs board)
44

USE AND NAVIGATION CONTROLS

Operate mode / standby mode
As soon as you turn on the rear switch (position 1), the preamplifier
is in functional mode. To activate its standby mode, you just have
to press and hold the left knob of the preamplifier. When starting
up, an initialization screen appears with the name of the product:
elipson | P1
If you press and hold the left knob again, the device goes into
standby mode, displaying a symbol
the left-hand side as shown below.
and a small red light on