Optional Modules - Boards; Installation; Updating; Dac Board - Elipson REFERENCE Serie Manuel D'utilisation

III. OPTIONAL MODULES – BOARDS (FOR P1)
PHONO BOARD (MM & MC)

• Installation

Make sure the unit is completely turned off.
By hand, remove the two knurled screws to remove the plate.
Insert your new board, being sure that the PCB follows the guide
notches and then press lightly on the back plate of the board
to insert it completely. Now you just have to tighten the knurled
screws to secure the whole thing.

• Updating

Once the board is in place, your P1 preamplifier automatically
detects this optional card.
You now have the PHONO source in the menu of your device.

DAC BOARD

• Installation
If you want to use the DAC module with a Windows computer,
you must manually install its driver, unlike a computer under IOS.
To do this, we invite you to download the "driverMDAC_1" folder
available on the page of your device Reference of Elipson's
website : www.elipson.com. The installation procedure is detailed
in a PDF file in this folder.
In general, make sure that the device is completely turned off.
By hand, remove the two knurled screws to remove the plate.
Insert your new board, making sure that the PCB follows the guide
notches and then press lightly on the back plate of the board to
insert it completely. You just have to tighten the knurled screws to
secure the whole thing.
• Updating
Once the board is in place, your P1 preamplifier automatically
detects this optional board .
You now have the USB, OPTO & COAX sources in the menu of your
device.
EN
49