Instructions For Use - Roborock WD1S1A Manuel Utilisateur

Instructions for Use

Filling the Clean Water Tank
1. Push the Clean Tank Release and remove the clean tank.
2. Turn the clean tank upside down and open the plug. Add
enough clean water to clean the required area. If deep cleaning,
add the Roborock floor cleaner diluted according to the guidance
on the cleaner bottle. Do not add excessive cleaner.
3. Close the water tank cover and make sure that it is in place.
4. Reinstall the clean tank bottom first then push inward to
secure it in place.
Notes:
• To prevent corrosion, only use cleaning solution provided by Roborock.
• To avoid deforming the water tank, only use cold water.
Starting the Vacuum
1. Tilt the body to a comfortable angle and press Power to start
the vacuum. The current battery and mode are displayed in the
center of the screen, and the dirt level is indicated at the top.
2. To prevent dirty water from leaking out, keep the vacuum upright.
Do not lay it flat.
Note: Power cannot be used when the vacuum cleaner is charging.
12